RoboCat 270mm 3K Carbon Fiber Mini FPV Racing Quad

Excl. VAT: £22.49 Incl. VAT: £26.99

Availability: Pre Order

Pre-Order
Excl. VAT: £22.49 Incl. VAT: £26.99
We Accept: Visa Paypal Amex Master Card
Description

The RoboCat 270mm 3K Carbon Fiber Mini FPV Racing Quad is a lightweight air-frame, it only weighs 170 grams, has good durability and will stand out from the other First Person View quad racers at the flying field. The Robocat 270mm is not short on features found in other FPV race quads, the core of the Robocat's air-frame is made from very strong 3K carbon fiber which is 1.5mm thick with supporting aluminium spacers to keep the weight down. The arms are cut from 3mm carbon fiber plate to add additional strength to this racing quad, this gives the best balance between weight and strength. The maximum recommended take off weight for the Robocat is 450 grams including the battery.

The body shell of the Robocat 270mm is made from a tough Lexan material that will allow the craft to have great finished look as all the wires and other parts are shielded from sight, the other advantage to the Robocat's shell is the better aerodynamics while FPV racing. The body shell makes it easy to access the internals for service or repairs, rotation of the shell will allow you to gain access in just a few seconds without needing to take apart the air-frame. To help keep the internals of the Robocat neat and tidy while building you can use the Robocat 270mm Power Distribution Board, this comes with voltage regulators and will help remove any noise on the power lines with an LC filter.

Internal space on the Robocat 270mm 3K carbon fiber FPV racer air-frame means that you can power from either a 3 or 4s LiPo battery, cells up-to 2200 mAh will fit in the air-frame. With enough room to install all the other important parts, the battery is installed in the mid plate section, on the lower internal plate of the Robocat's frame you can fit a Naze or a CC3D flight controller. With standard spacing holes of 16 & 19mm on the arms of the Robocat you can install 20 Amp ESC's and motors between 18xx & 22xx allowing for a wide range of power systems and performance to meet the needs of all the FPV Race drone pilots. The Recommended propeller size on the Robocat is 5 inch.

A "pre-angled" FPV camera mount is installed in the Robocat's nose, this points the camera in an upwards direction, the view it provides is an optimised viewing angle for flying at higher speeds or when in racing conditions with other pilots. The camera is protected by the body shell and extended lower carbon frame plate, this acts like a bumper in harder landings or crashes helping to protect the camera from damage.

Full build instructions are supplied with the RoboCat 270mm 3K Carbon Fiber Mini FPV Racing Quad air-frame, which make putting together this mini FPV racer quick and easy.

Reviews

Write Your Own Review

Only registered users can write reviews. Please, log in or register