Lumenier LUX Flight Controller

Excl. VAT: £27.00 Incl. VAT: £32.40

Availability: Pre Order

Pre-Order
Excl. VAT: £27.00 Incl. VAT: £32.40
We Accept: Visa Paypal Amex Master Card
Description

Lumenier LUX Flight Controller

Lumenier LUX Flight Controller Has Been Replaced With The Lumenier LUX V2 Flight Controller

The Lumenier LUX flight controller is a high quality flight control using a powerful F3 processor with the top of the line hardware. The Lumenier Lux flight controller allows you to unleash the full capabilities of your FPV Racing Quadcopter, with the Lumenier LUX Flight Controller you can achieve gyro refresh rates of up to 8kHz (high speed SPI) using the popular Betaflight and Raceflight firmware along with ultra low looptimes. The LUX is Cleanflight compatible using the RACE target. The Lumenier LUX is a very low profile board, allowing for it to be mounted in a variety of ways. The Lumeniner Lux board also comes with a set of pin headers you can solder on if needed. Alternatively, the signal wires can be soldered directly to the pads to save on size and weight. The LUX supports PPM or Serial RX (including Futaba, FrSky, S.BUS). A signal inverter is already included for S.BUS. Please note: Baseflight firmware is not supported, and PWM input for individual channels is not supported.


Hardware Features: 

  • USB Conflict resolution - Hardware inversion, SBUS or telemetry can be used on any of the 3 available hardware serial ports. USB will not interfere with peripherals.

  • High Speed SPI 8kHz Gyro

  • MPU interrupt connected to F3, allowing the F3 to know immediately when fresh data is available.

  • Dedicated Boot button for easy firmware flashing.

  • Reinforced solder pads for trouble-free direct soldering.

  • Extremely low profile design.

  • Recessed, sideways pin headers. Also enables soldering of all wires directly to pads without use of any pin headers.

  • Integrated FRSky RSSI Filter (RC filter).

  • Input voltage 6v to 24v. Power the board directly from flight pack up to 6S (on 'BAT' pad only!).

  • VIN + VBAT merged - A single wire to power the board will provide voltage input and Telemetry/OSD voltage data.

  • Filtered voltage output - output 5v 1A (and 3.3v where applicable) to power peripherals such as GPS, RX, BLACKBOX, OSD. 5v/3.3v RX selectable.


Software & Hardware Features: 

  • Cleanflight support (Lux target).

  • BLHeli flashing supported (BLHeli bootloader pass-through).

  • Raceflight ready

  • Betaflight ready


Specifications: 

  • STM32F303RCT6(256kB flash) 32-bit processor

  • MPU6500 Gyro/Accelerometer

  • High quality, gold plated PCB

  • Highest quality components, individually sourced to meet Lumenier standards

  • Micro USB connector for programming

  • Dimensions: 36x36x6mm (includes USB in height)

  • Mounting Holes: 30.5mm square to center of holes

  • Weight: 6g



Reviews

Write Your Own Review

Only registered users can write reviews. Please, log in or register