Lumenier 30 amp ESC SimonK AutoShot Firmware

Excl. VAT: £16.65 Incl. VAT: £19.98

Availability: In Stock

In Stock
Excl. VAT: £16.65 Incl. VAT: £19.98
OR
We Accept: Visa Paypal Amex Master Card
Description

The Lumenier Mini 30 amp ESC with customised SimonK firmware and OneShot auto-detect has been desinged to work with the mini 250 sized FPV Race drones, it's the perfect ESC to use on the Lumenier QAV250. This ESC is small in size, it only measuers 51 x 25 x 10mm while supporting 30 Amps on a 4s LiPo. The Lumenier Mini 30 amp ESC comes pre-loaded with the newest firmware, which is compatible with all the new features like "OneShot" (it will auto-detect if OneShot is enabled), Comp PWM (similar to KISS braking feature), compatible with all Lumenier motors up to 4 cell LiPo. The Lumenier 30 amp AutoShot ESC's have been tested and are compatible with all Lumenier motors (FX1806, FX2206, FXC2206, RX2204, RX2206, FX2208), 2S-4S, both 5" and 6" props without sync loss issues or cogging.

The Simonk AutoShot firmware is pre-calibrated with endpoints 1060us - 1860us. This corresponds to the default endpoints in both Baseflight and Cleanflight (The ESC is configured for cleanflight & baseflight by default). Therefore the "Calibration" procedure is not necessary or recommended. "Calibrate" these ESC's at your own risk. Removal of the red wire in the signal cable is ok if you don't need 5v power out, but both the ground (black) and signal wire (white) need to be connected to the flight controller. Do not connect only the signal wire alone. 

Features:

  • Active Braking / Damped Light / Comp_PWM

  • AutoShot (OneShot125 / FastPWM Auto Detect)

  • Customized to drive all motors without sync issues or cogging.

To enable the new features on Baseflight:

  • On Configuration tab, check "Enable OneShot" and "Enable FastPWM"

  • Scroll down and click "Save" 


To enable new features on Cleanflight:

  • On Configuration tab, check the "Enabled" box next to "ONESHOT125" Feature

  • Scroll down and click "Save" 

Specifications:

  • Max continuous load: ~30 amps

  • Burst Current: 40A/10sec

  • BEC: 5v/1amp max

  • Lipo Cells: 2 to 4 cells

  • Bare Cables

  • Weight: 26g (board) 32g (total with wires and connectors)

  • High quality N-FET only flashed with SimonK firmware and 5v 1A BEC 

Dimensions

  • 51 L x 25 W x 10 mm H

  • 185 mm signal wire / 5v power

  • 85 mm bare motor wires

  • 70 mm ESC power wires

An ESC has either P-channel and N-channel FETs mixed or N-channel FETs only. The ESC's which use only N-channel FETs have the advantage of lower resistance, less losses and hence more efficiency. Learn more about N-channel and P-channel directly from Simon Kirby here.

Reviews

Write Your Own Review

Only registered users can write reviews. Please, log in or register