Call us:01189 38 01 39

Lumenier Mini 20A ESC with SimonK AutoShot 5V 1A BEC 2-4s
Product PDF

Be the first to review this product

Pre-Order
Excl. Vat: £16.66 Incl. Vat: £19.99
OR

Quick Overview

Lumenier Mini 20A ESC with SimonK AutoShot 5V 1A BEC 2-4S. 2740

Lumenier Mini 20A ESC with SimonK AutoShot 5V 1A BEC 2-4s

Double click on above image to view full picture

Zoom Out
Zoom In

More Views

Lumenier Mini 20A ESC with SimonK AutoShot 5V 1A BEC 2-4S


Features

The Lumenier Mini 20 amp ESC with customised SimonK firmware including OneShot auto-detect is the perfect ESC to use on mini FPV racing quads, such as the QAV250, QAV210 and QAV180. This ESC is small in size 27 x 14.5 x 6mm and big on power, allowing 20Amps on 4s Lipo packs. The ESC comes pre-loaded with the newest Simok K firmware, which is compatible with new features like "OneShot" (no soldering required, it will auto-detect if OneShot is enabled), Comp PWM (similar to KISS braking feature), compatible with all Lumenier motors up to 4 cell.

The Lumenier 20 amp AutoShot ESCs has been tested and are compatible with all Lumenier motors (FX1806, FX2206, FXC2206, FX2208), 2S-4S, both 5" and 6" props without sync loss issues or cogging. These ESC's are now supplied in the later ARTF and RTF Lumenier kits including the "RX" range of micro brushless Lumenier motors. Such as the RX2204-14 2300Kv, RX2206-13 2000KvRX2206-11 2350Kv, RX1806-14 2300Kv and the RX1806-13 2500Kv.

Features.

  • Active Braking / Damped Light / Comp_PWM

  • AutoShot (OneShot125 / FastPWM Auto Detect)

  • Customized to drive all motors without sync issues or cogging.

To enable new features on Baseflight:

  • On Configuration tab, check "Enable OneShot" and "Enable FastPWM"

  • Scroll down and click "Save" 


To enable new features on Cleanflight:

  • On Configuration tab, check the "Enabled" box next to "ONESHOT125" Feature

  • Scroll down and click "Save" 

Specification.

  • Max continuous load: ~20 amps

  • Burst Current: 30A/10sec

  • BEC: 5v/1amp max

  • Lipo Cells: 2 to 4 cells

  • Cables are fitted with female 2mm bullet connectors

  • Weight: 4g (board) 8g (total with wires and connectors)

  • High quality N-FET only flashed with SimonK firmware and 5v 1A BEC

Dimensions: 
  • 27mm L x 14.5mm W x 6mm H

  • 100mm signal wire / 5v power

  • 50mm motor wires (including 2mm bullet connector)

  • 70mm ESC power wires

Note: An ESC has either P-channel and N-channel FETs mixed or N-channel FETs only. The ESCs which use only N-channel FETs have the advantage of lower resistance, less losses and hence more efficiency. Learn more about N-channel and P-channel directly from Simon K here.